Data Centre


Western Dig's MAMR is so phat, it'll store 100TB on a hard drive by 2032

Using microwaves to fry bits into submission

By Chris Mellor


WDC has given up on heat-assisted magnetic recording (HAMR) and is developing a microwave-assisted technique (MAMR) to push disk drive capacity up to 100TB by the 2030s.

It's able to do this with relatively incremental advances, avoiding the technological development barrier represented by HAMR. These developments include multi-stage head actuation and so-called Damascene head construction.

The current Perpendicular Magnetic Recording (PMR) technology uses vertically oriented magnetised areas in a disk drive's recording medium. Assume the recording medium has a uniform distribution of grains within it. A disk drive's write head magnetises an area of grains (a bit) with either a north pole or a south pole using an electrical field.

The grains remain so-magnetised until re-magnetised by the write head. If we shrink the grain area to increase the areal density of the disk, and hence its capacity, they gradually become unstable, with their magnetism being affected by the magnetic state of their neighbours and temperature changes.

PMR drives have passed 1Tbit/in2, with Toshiba's single platter MQ04 2.5-inch disk drive and its 1TB capacity as an example. But the technology can't go much further. The next step has been to move to a recording medium which is more stable in retaining its magnetised domains, and hence harder to write data as the grains have to be coerced more strongly into changing their magnetic polarity when data is written.

With HAMR this is done by applying an intense blast of laser-induced heating to the grains, which makes it easier to alter their magnetic polarity. But adding the laser-heating source to the read/write head adds cost and difficulty, and ensuring its reliability, longevity and also that of the recording medium as it gets intensely heated and cooled repeatedly is also a challenge.

Seagate, Toshiba and WDC have all been researching and trying to develop HAMR technology.

These difficulties have been prolonged, so much so that WDC has decided MAMR is practical whereas HAMR is not.


MAMR uses a different technique to coerce the magnetic domains to change polarity. It adds microwaves to the write head, using a spin-torque oscillator (STO) to generate them. Electrons in a magnetised area have a spin state, tending to spin one way or another. By applying microwaves at the right frequency a resonance effect can alter the spin state and make it easier for the write head's electrical field to alter the magnetic polarity of the domain.

The STO's microwaves perform the same function, overcoming coercivity, as the HAMR head's laser but without the disadvantages.

It thinks it can reach a 4Tbit/in2 areal density over time using MAMR technology, with a 15 per cent compound annual growth rate (CAGR) in capacity.

Click to enlarge

Damascene technology

Another incremental advance by WDC has been in its read/write head-building technology where it has developed the capability to add an STO device to the head. It calls it a Damascene process, in a nod to the process of forging Damascus steel for sword blades up until the 18th century.

WDC describes (PDF) how it does this: "The main pole and the structures of the write head in the Damascene process are shaped and tapered by depositing and etching magnetic and non-magnetic materials. This process also enables the formation of a full wrap-around shield that helps to focus the magnetic field on to the target area being written while reducing interference on adjacent tracks."

This enables tracks to be narrower and packed more closely together. That means the read/write head has to be positioned more accurately over the tracks, and WDC has a way to do that too.

Multi-stage actuation

All disk drive manufacturers use multi-stage actuators to position the read/write heads over the disk platter surfaces tracks. Think of the read/write head as being at the tip of an arm. Imagine a single fingered hand at the end of your arm which has just a shoulder joint to position the finger over an object. Positioning would be crude. Add an elbow joint and positioning control gets finer. Add a wrist and it gets finer still. Add a finger joint and, yes, it gets even better, and then knuckles and... you get the picture.

WDC has moved the final joint closer to the read/write head and called it a multi-stage micro actuator with finer track positioning capability.

The combination of the micro actuators, the better shaped read/write head (Damascene process) and MAMR technology means WDC can see a way to 4Tbit/in2 drives quicker than with HAMR.

It says MAMR promises to enable hard drives with 40TB of capacity and beyond by 2025, and continued expansion beyond that timeframe. We played around with a spreadsheet, a 15TB drive starting point in 2018, and 15 per cent capacity CAGR to produce this chart:

Click to enlarge

It shows a 106TB drive in 2032.

WDC believes that MAMR will enable disk drives to retain a cost/GB advantage over SSDs out to the 2030s:

Click to enlarge

The differential is 10x and that takes QLC flash into account.


If WDC is right then both Seagate and Toshiba are stuck up technological blind alleys with HAMR. It will introduce MAMR drives for sampling in 2019. Assume Seagate and Toshiba will need at least a year to catch up and we could imagine WDC having a 2TB/drive capacity advantage in 2020 and, no doubt, hoping to retain it going forward as it refines its technology. Hey MAMR, you're so good to me. ®

Sign up to our NewsletterGet IT in your inbox daily


More from The Register

No pain, no $1.3bn Bain gain: Seagate slips Tosh/WD chippery into Nytro SSD ranges

NAND that... is how you get skin in the flash game

Toshiba crams 14TB into another helium drive, this time with SAS boost

MG07SCA is a workhorse designed for constant use

So solid spinning crew Seagate on hunt for new chief beancounter

Plus: Splashes profits on dividends and share buy-backs, according to latest figures

What a pain for poor old Bain: Toshiba $18bn flash chip biz sale stalls

+ Comment Memory business deal could be sunk

WDC adds an FAQ to SanDisk-Tosh chip arm wrestling match

The world according to WDC

Toshiba gets NASty: Soups up hi-cap enterprise drive

9-platter capacity drive modified for NAS use

Seagate passes gassy 14TB whopper: He He He, one for each of you

Misses no one: PCs, NAS, workstations, enterprise, surveillance

Two years and $19bn later: What happened to WD's SanDisk enterprise flash advantage?

Analysis Market position evaporating in front of our eyes

Seagate's Barracuda SSD bares its teeth at PC, laptop upgraders

SATA flash drives to put low-cap disk on endangered list

Whoosh, there it is: Toshiba bods say 14TB helium-filled disk is coming soon

Arriving by the end of 2017